How to repair a snag on work pants?

Take your work pants with holes, an invisible iron-on patch that you can easily find at the supermarket and a pair of scissors. First, cut off the little threads sticking out and clean up the tear as best you can. Then turn the pants inside out. Cut out a part of the invisible iron-on patch in the shape of the hole, leaving a margin of 1 to 2 cm around it. Then place the shiny side on the fabric and iron it with an iron. Finally, remove the paper and turn the pants inside out.

How to mend a tear on a torn garment or fabric?

A sharp object or wear destroys the fabric of your favorite garment? Do not panic ! With a little material and at least as much patience, the tear can be mended quickly and almost discreetly.

To repair tears or tears, you will need a few tools: an iron, a iron-on cloth, thread, a needle, scissors and also a bit of patience ! It is better to wash your laundry beforehand to ensure that the glue adheres firmly to the fabric. Smooth the edges by ironing the holes and trimming the excess thread to make the edges neat and tidy.

Cut the iron-on canvas to an exact size. The piece should be slightly larger than the hitch. Make sure the corners are well rounded so they don't come off easily. Place the adhesive side (shiny side) of the canvas on the opposite side of the fabric, then press the iron firmly and rock it back and forth to secure it. You still have to be careful and carefully read the label of workwear as well as the ironing instructions. Follow the instructions for temperature and ironing time. Otherwise, you risk burning the fabric or iron-on canvas.

When the canvas is glued, it is best to sew the edge to the fabric so that it does not come off after a few washes. Thread the yarn through the needle and tie the ends. Starting from the wrong side of the fabric (so that no knots appear), sew with the needle all the way to the edge of the fabric on both sides of the fabric. When you reach the end, tie a knot again and cut off the excess thread. You will hardly see anything! Of course, anyone with a sewing machine can do this, but you can also do it easily by hand.

How to hide a big hole in the knee of pants with a sewing machine?

Sewing a large hole at the knee of work pants with a sewing machine seems to be an ideal solution to hide the tear in your pants. Choose a bar tack (a very tight zigzag stitch) on your sewing machine. Place a tack under the hole and sew very tightly to secure all edges of the hole to the patch. Sew the reinforcement in place and secure the reinforcement in place!

Start by cutting around the hole to remove frayed or excessively worn fabric. Then fold the four edges inwards and secure them with pins. Then fold the corners and pin them. Cut the jeans larger than the hole to be repaired. It is better to be too big and then cut off the excess at the end than to make a repair that is too small and too flimsy. Put the patches in your jeans and pin the holes as follows: remove the pin, then insert it through the crease and the patch. Do the same with all the pins. You have to be very careful not to pin the back of the pants at the same time.

Pieces are sewn in place with a hemstitch. Thread the needle and tie one end! Stick the needle between the pleats and hide the yarn knot there! Then insert the needle diagonally into the piece as follows: try to keep the stitches fairly small and even. Continue around the room and remove the pin when no longer needed. When you're done, turn the pant leg upside down and trim the excess fabric from the patch. Use zigzag scissors or even regular scissors will do.